Assembly Instructions

ManualsBrandsBrayden Studio ManualsOutdoor & Patio FurnitureArbus Outdoor 6 Piece Dining Set with Cushions

This bench assimilates the shape of Tree Trunk at the long sides of the bench.

Therefore, the long sides of the bench is irregular in shape and is the intended design.

BENCH

CAUTION: You must read this before you proceed.

Page 1 of 5

Summary of content (5 pages)

PAGE 1
BENCH CAUTION: You must read this before you proceed. This bench assimilates the shape of Tree Trunk at the long sides of the bench. Therefore, the long sides of the bench is irregular in shape and is the intended design.
PAGE 2
No. Picture Description Qty A Bench ( with Folded Leg Panels) 1 B Support Bar 1 Description Qty C Bolt (M8x25mm) 13 D Washer (M8.5/16x2mm) 13 E Spanner Wrench 1 No. Picture Before Beginning Assembly: Read instructions, cover to cover. Have 2 adults on hand for assembly. Do not assemble on flooring or carpet. Assemble on a clean non-marring surface (packing foam). Save all packaging until finished.
PAGE 3
Step 1 Unpack and place all parts on a clean non marring flat surface . Step 2 Place the Bench (A) facedown, onto a clean, soft surface to avoid any scratches or damages to the product. Lift legs upwards and outwards until the braces are met at position to the base of the bench, as shown in the above pictures. Step 3 Pic.1 Attach the Support Bar (B) to the Bench (A) You may need to apply a little pressure to the Legs - pushing outwards, so as to enable the Support Bar (B) to be slotted into position.
PAGE 4
Step 4 Pic.2 Secure Legs to Bench by using Bolts (C) and Flat Washers (D) with Spanner Wrench(E) as shown in Pic.2 at all 8 positions. Loosely tighten the Bolts, up to 80%. Turn it over and Sit on it. Then turn it over again, in a sequential manner, gradually tighten each Bolt until all bolts are evenly secured. CAUTION: When tightening these screws, tighten sequentially. DO NOT tighten any screw fully and then towards the next one. This would cause the frame to warp.
PAGE 5
Page 5 of 5