Assembly Instructions

Step 1
Unpack and place all parts on a clean non marring flat surface .
Place the Table (A) facedown, onto a clean, soft surface to avoid any scratches or damages to the
product.
Lift legs upwards and outwards until the braces are met at position to the base of the table, as
shown in the above pictures.
Step 2
Step 3
Attach the Support Bar (B) to the Table (A)
You may need to apply a little pressure to the Legs - pushing outwards, so as to enable the Support
Bar (B) to be slotted into position.
Using Bolts (C) with Flat Washers (D), tighten the Bolts by using Spanner Wrench (E), as shown in
Pic.1
Loosely tighten the Bolts, up to 80%.
Pic.1
Page 3 of 5