TABLE CAUTION: You must read this before you proceed. This table assimilates the shape of Tree Trunk at the long sides of the table. Therefore, the long sides of the table is irregular in shape and is the intended design.
No. Picture Description Qty A Table Top ( with folded legs ) 1 B Support Bar 1 Description Qty C Bolt (M8x25mm) 13 D Washer (M8.5/16x2mm) 13 E Spanner Wrench 1 No. Picture Before Beginning Assembly: Read instructions, cover to cover. Have 2 adults on hand for assembly. Do not assemble on flooring or carpet. Assemble on a clean non-marring surface (packing foam). Save all packaging until finished.
Step 1 Unpack and place all parts on a clean non marring flat surface . Step 2 Place the Table (A) facedown, onto a clean, soft surface to avoid any scratches or damages to the product. Lift legs upwards and outwards until the braces are met at position to the base of the table, as shown in the above pictures. Step 3 Pic.1 Attach the Support Bar (B) to the Table (A) You may need to apply a little pressure to the Legs - pushing outwards, so as to enable the Support Bar (B) to be slotted into position.
Step 4 Pic.2 Secure Legs to Table by using Bolts (C) and Flat Washers (D) with Spanner Wrench(E) as shown in Pic.2 above, at all 8 positions. Loosely tighten these Bolts, up to 80%. Turn it over, with assistance from your partner, stand to each of the longside of the table. EXERT pressure, floorwards, onto the table. This pressure will help the legs and table top to reach alignment at all joints. Check for wobbleness.
Page 5 of 5
