Caution : You must read this before you proceed TABLE CAUTION : This Table is NOT a TOY. Keep your child / children at bay during the assembly process. For moving the Table and to prevent damage to the Table, two adults are needed to execute this action.
Label Picture Description QTY A Table 1 B Leg Support Bar 2 C Middle Support Bar 1 D Side Support Bar 2 Label Picture Description QTY ① Long Bolt (M6x50mm) 13 ② Medium Bolt 1 (M6x45mm) 7 ③ Medium Bolt 2 (M6x40mm) 5 ④ Short Bolt (M6x30mm) 5 Sleeve Nut (6x13mm) 11 Allen Key 2 2
Before Beginning Assembly: OVERVIEW Table FRONT FACING Leg Support Bar This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 Step 2.1 Step 2.2 A 2.1) With the assistance of an adult helper, unfold the Table(A) as shown. Note: When unfolding the Table(A), you must hold the Legs against the Table(A) 2.2) Then lay the Table(A) facedown onto a clean, flat surface to avoid any scratches or damage to the product.
Step 3 Step 3.2 n o Step 3.1 o k 3.1) Lift legs upwards and outwards until they are flush with the base of the Table, as shown in the above picture. 3.2) Insert 3 Medium Bolts 1 (k) and Sleeve nut (n) through the mounting position of the Legs and affix the Legs using Allen Key(o) Only loosely tighten the Bolts. Repeat the same process with the other Legs. Step 4 Step 4.1 B m o Step 4.2 A m o Position Leg Support Bar(B) as shown in picture above. 4.
Step 5 C o n j o Position Middle Support Bar(C) as shown in picture above. Insert 4 Long Bolts(j) and Sleeve nut (n) through the mounting positions and affix the Middle Support Bar(C) to Table(A) using the Allen Key (o) Only loosely tighten the Bolts. Step 6 o j Step 6.1 ② D Step 6.2 l o Position Side Support Bar(D) as shown in picture above. 6.1) Insert 4 Long Bolts(①) through the vertical mounting positions of the Side Support Bar(D) and affix using Allen Key(o) 6.
Step 7 Stand the Table right side up. Your Table is ready for use. This Table can only be used on a flat, level surface.
