Assembly and Installation Instructions

ManualsBrandsBrayden Studio ManualsLantern Outdoor Wall LightingBenites Outdoor Wall Lantern

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Parts:

Green Grounding

Screw (E)

Headless

screw (D)

Mounting Screw (B)

Wire Nut (C)

Lock Nut (F)

Cross Bar (A)

Ball Nut (H)

Fixture Grounding Wire

House Grounding Wire

Green Grounding Screw (E)

Wire Nut (C)

Mounting Screw (B)

Headless Screw (D)

Outlet Box

Fixture Wire

Lock Nut (F)

Back Plate

Fixture

Ball Nut (H)

Rubber Pad (G)

Cross Bar (A)

Rubber Pad (G)

1. Attach the headless screws to the cross bar, then secure it with lock nuts.

2. Attach the cross bar to the outlet box by using two mounting screws.

3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections using the wire

nuts:

---The black wire from the fixture to the black wire from the power source.

---The white wire from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the cross bar with the green grounding screw. Then connect it to

the house grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

Installation Steps

Bulb Type T10 MAX 60W

(not included)

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Attach the fixture to the cross bar by inserting the headless screws, then secure it with the ball nuts. CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall surface to prevent water from seeping into the outlet box. 5. Install a bulb (not included). See relamping label on socket area or packaging for maximum allowed wattage.