Assembly Instructions

ANTI - TIPPING KIT

PAGE 2 OF 2

PARTS IDENTIFICATION HARDWARE IDENTIFICATION

A DRESSER 1PC 1 SHORT SCREW 1PC

THIS TIP RESTRAINT MUST BE ATTACHED TO A WALL

STUD USING LONG SCREW ENCLOSED.

STEP 1

Attach a bracket securely to the back top rail of the dresser

using short screw provided, through the smaller hole.

STEP 2

Locate the other bracket on the wall over a wall stud and two

inches below the mounting bracket secured to the back of

dresser. Atttached to the wall stud using the long screw

provided, through the smaller hole.

2 LONG SCREW 1PC

3 CABLE TIE 1PC

4 L BRACKET 2PCS

STEP 3

Place the dresser into position so both mounting brackets are vertically in line. Lace the end of the restraint strap through the

larger hole in each mounting bracket. Bring both ends together and slide the flat end through the locking end and draw it

through until all slack is removed. Confirm that the strap is securely laced and locked.