Assembly Instruction

3of3
FINISH: POLISHED CHROME
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
PENDANT LIGHT
(Step 3B Contined)
nut and lock washer and then screwing the mounting screws in or
out of the crossbar until the correct length is achieved. Once the
Ceiling Canopy (A) is secure, remove the mounting ball and Ceiling
Canopy (A) and proceed to Step 4B.
STEP 4B - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 4B
STEP 5B - Install the Fixture Body
A. Position the Ceiling Canopy (A) and Fixture Body onto the Crossbar
Assembly (AA). Place the holes in the Ceiling Canopy (A) over the
mounting screws. Secure the Fixture Body by using the mounting
balls and hand tighten the mounting balls until snug.
Mounting Screw
A
AA
Mounting Ball
Figure 5B
STEP 6B Install Bulbs and Glass Panels-
A. Insert bulbs onto sockets and screw snugly into place..
B. Remove Lock Screws from Socket Assembly (I). Attach Glass
Panels (J) to Socket Assembly (I) with wider edge is on the top.
Secure by threading Lock Screws back into Socket Assembly (I). Do
not release your hands with Glass Panels (J) until hand tighten Lock
Screws until snug
Your fixture is now assembled and ready to use.
Enjoy!
SEMI-FLUSH
5” Dia.
10.5”
49.25” OVERALL
HEIGHT (2) 6” AND
(2) 12” RODS
INCLUDED
Lock Screw
J
Bulb (not
supplied)
Socket
Figure 6B
23” Dia.
23” Dia.
5” Dia.
10.5”
10.75”