Assembly Instruction

STEP 5 Install Ceiling Canopy to Ceiling-
A. Attach the Ceiling Canopy (A) over the end of the Nipple (DD) and
secure with Lock Ball (EE). Hand tighten until snug.
Figure 5
A
DD
EE
STEP 6 - Install Glass Panels and Bulbs
A. Remove Knobs and Washers from Shade Holder. Insert Glass
Panels (G) into cage and place Glass Panels over Bolts in the
Shade Holder. Secure by threading Washers and Knobs back onto
Bolts. Tighten gently until snug.
B. Insert bulbs onto sockets and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
FINISH: WESTERN BRONZE
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
Figure 4
STEP 4 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
White wire
from supply
Ribbed side of wire from fixture
identified with the Label “N”
Black wire from
supply (or Red)
Smooth side of wire from fixture
identified with the label “L”
Ground wire
from supply
Ground wire
from fixture
G
Socket
Shade
Holder
Washer
Knob
G
Bolt
Figure 6
36”
13”
13.75”
32.25”
7”
12”
4.5”
54” OVERALL
HEIGHT INCLUDES
(4) 6” RODS AND
(4) 12” RODS
T9 Vintage Bulb
(recommended
but not supplied)
2of2