Assembling & Installation Instructions

ManualsBrandsBrayden Studio ManualsCeiling LightsKramer 9 - Light Unique Tiered Chandelier

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box. The junction box is not include.

2. Carefully unpack your new fixture and lay out all the parts on a clear area.

Take care not to lose any small parts necessary for installation.

3. Thread nipple (C) into loop (F) until snug. Thread other end of nipple (C) with

loop attached into single bar (D) until snug. Place lock washer (B) over end of

nipple protruding through single bar and thread hex nut (A) onto nipple until

tight. Take this single bar assembly and mount to ceiling junction box with

junction box screws (E). Tighten screws securely with screwdriver.

4. Attach the pipe thread(N) to the center coupling of the lamp body(S), by turn it

clockwise until tighten. Attach the tube(Q)/cover(P) insert the pipe thread, lock

them securely with the round nut(O). Slide the electrical wires through the

tubes(M)/(L)/(K) , loop(J), loop collar(H) , loop(F)and canopy(G).

5. Raise the tube(M) to top pipe thread of lamp body(S), raise the tube (L), tube

(K) and loop(J) to the pipe thread in order, then by turning it clockwise until

tight. Open the link(I), hooked the loop(F) and loop (J), close the link(I).

6. While holding the fixture lamp towards the ceiling , connect the electrical wires

as Shown in Fig.2, making sure that all wire nuts are secured. You may have

to wrap the connections with electrical tape. If your outlet has a ground wire

(green or bare copper), connect the fixture ground wire to it. Otherwise

connect fixture’s ground wire directly to the Mounting plate with the green

screw provided. After wires are connected, tuck them carefully inside the

Junction box.

7. Install the light bulbs(not included) in accordance with the fixture

specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

8. Raise the canopy on to the Junction box, lock it securely with the loop

collar(H). Attach the glass(R) insert to the lamp holder, rotate the glass until

tighten.

Your installation is now complete. Return power to the junction box

the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

FIG.1

Thank you for purchasing a product.

Need assistance with parts or assembly? Please call customer service