Assembly Instructions

Place the Footrests(F) beween the Legs as shown.
Attach the bottom side of Footrest(F) to the Legs using Bolts(②) and
Washers(③) with Alley Key(④).
Then turn the Barstool over and attach another side of the Footrest(F) using
Bolts(②) and Washers(③) with Alley Key(④).
Do not fully tighten bolts.
Step 4
Place the Barstool on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Barstool some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Barstool freely and vertically with the four legs, hitting the ground, at
the same time.
This Drop Test will help to ensure that all the Bolts and gaps all reach full
alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, proceed to tighten all the Bolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute the same drop test.
If the Barstool is not stable it could lead to damage to the product.
Page 6 OF 8