Installation Instruction

PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from the canopy.
4. Secure the mounting plate to the junction box using junction box screws (B1). The side of the mounting back plate marked
“GND” must face out.
5. Adjust the xture wire length by pushing the cable gripper on the canopy and
pulling the wire as desired. Make sure the wires are the same length.
CONNECTING THE WIRES (Fig. 2)
6. Connect the Driver input wires with junction box wires as shown in Fig. 2,
making sure that all wire connectors (A1) are secured. If your outlet box has
a green or bare copper ground wire, connect the xture’s ground wire to it.
Otherwise, connect the xture’s ground wire directly to the mounting plate
using the green screw provided. After wires are connected, tuck them carefully
inside the junction box.
7. Place the xture over the mounting plate and secure it with
mounting screws (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Gr
een or Bare Copper
(Ground)
Fig. 2 Wiring
Plastic Anchor
Junction Box Screw
Back Plate Dimensions
Mounting Screw
Canopy
Driver
Cable Gripper
Mounting Back Plate
Ground Wire Screw
Junction Box
Wire Connector
Wood Screw
Ground Wire
E1
B1
C1
A1
D1
FIG. 1
INSTALLATION INSTRUCTION
Ø 8 15/16"
1 9/16"
3 9/16"
LED Pendant
2