Installation & Assembly

Please consult your electrician for hanging fixture and wiring.

PRODUCTS ARE NOT INENDED

FOR COMMERCIAL USE.

MADE IN CHINA

Page 1 of (2)

The fixture is designed to dim with a standard

Triac forward phase dimmer. Dimming levels

will vary by dimmer.

Below is a list of recommended dimmers:

Lutron MACL-153M

Lutron DVL-153P

Lutron SCL-153P

Leviton IPL06-10Z

Leviton 6674-POW

Due to inrush current wattage should not exceed

150 watts of product for a 600 watt dimmer.

WARNING: Wires need to be connected to driver

found in canopy and should not be connected

directly to power source or a short may occur.

To prevent water intrusion, caulk around back-plate

where fixture meets the wall using outdoor silicone

sealant. Leave a small gap at the bottom to allow

moisture to exit.

WARNING: Wires need to be connected to driver

found in canopy and should not be connected

directly to power source or a short may occur.

PAGE 1
Please consult your electrician for hanging fixture and wiring. The fixture is designed to dim with a standard Triac forward phase dimmer. Dimming levels will vary by dimmer. Below is a list of recommended dimmers: Lutron MACL-153M Lutron DVL-153P Lutron SCL-153P Leviton IPL06-10Z Leviton 6674-POW Due to inrush current wattage should not exceed 150 watts of product for a 600 watt dimmer.
PAGE 2
FOR USE ONLY WITH 12V LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT EXCEED 25 AMPS, 15 VOLT MAXIMUM. WARNING: Luminaires must be installed in accordance with the National Electrical Code (NEC) and local codes. Failure to do so will void thewarranty and may result in serious injury and/or damage to the luminaire. LUMINAIRES ARE NOT TO BE INSTALLED WITHIN 10 FT. (3.05M) OF A POOL OR SPA. SECONDARY CABLE IS NOT TO BE BURIED MORE THAN 6”.