InstallationandAssembly

2. Unfold the top half of the strip and apply to the wall, letting a little bit
of the wallpaper overlap the ceiling and adjoining wall. Make sure your
pattern is right side up!
3. Slide the paper into position so it lines up on the plumb line that you
created.
4. Using a wallpaper smoothing tool, gently press the strip to the wall. Be
careful not to stretch the wallpaper while positioning.
5. Unfold the bottom half and smooth into place.
6. Smooth the entire strip, working diagonally from the top down and
from the center outward, forcing out any air pockets.
7. Wash off excess paste with a damp sponge and clean water.
Remember always to use clean water.
TRIM WALLPAPER
1. Using the 6" putty knife as a guide, trim the excess paper along the
ceiling and baseboard with a sharp razor knife. Always use a sharp
knife or blade for every cut and do not to lift your knife when making
long cuts.
2. Wash paste off ceiling and baseboards with a wet sponge and clean
water.