Installation Instructions

1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
• 5 x 60W E26 A19 bulbs (50927
and 50928)
• 6 x 60W E26 A19 bulbs (50929)
2
4
2
CERTIFICATION: cULus DAMP
3
MOUNT CROSSBAR
If there is an existing fixture remove it.
Install the crossbar and mount it to the J-Box with
the supplied screws.
MAKE WIRE CONNECTION
Expose the supply wires from the J-box.
Gently pull the supply wires through the hole in the
crossbar plate. Connect the black supply wire to
the black fixture wire. Secure with the supplied wire nuts.
Connect the white supply wire to the white fixture wire.
Secure with the supplied wire nuts. Attach the green
J-Box wire around green hexagonal head screw or
connect it to the green supply grounding wire of the
fixture. Secure all wires with electrical tape
(not supplied). Tuck all wires carefully into the J-Box.
MOUNT THE CANOPY AND INSERT
THE BULBS
Fit the canopy up to the crossbar and secure with
the supplied side screws.
Insert the bulbs.
MAXIMUM WATTAGE 60W.
DO NOT EXCEED THE MAXIMUM WATTAGE AS
STATED ON THE WARNING LABEL AND
INSTRUCTION SHEET.
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW LIGHTING FIXTURE