Owner Manual

page 9
10. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10 for
remote control assembly instructions. If you have
already installed the wall control but do not wish
to use the handheld remote control, please
proceed to Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
Since this fan comes with LED bulbs, the dimmer
switch (labeled DIM and ON) has been pre-set
to the "ON" position (DIM). If you do not wish to
have dimming capability, please move the
switch to the "OFF" position (ON). [Refer to
diagram 2.]
Attach black faceplate to front of wall control;
press down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover
together until you hear a click at each end,
indicating that the remote control cover has
closed completely.
IMPORTANT: Store the remote control away
from excess heat or humidity. To prevent
damage to remote control, remove the battery if
remote control will not be used for long periods.
(top)
(bottom)
remote
control
cover
diagram 1
11
-
ON/ DIM
OFF
wall
control
face-
plate
remote control
cover, BOTTOM
post
hole
diagram 3
post
hole
remote control
cover, TOP
22
-
dimmer
switch
wall control
wire
wire
wire
11
-
ON/ DIM
OFF
12V battery
diagram 2
22
-