Owner Manual

3. Ceiling Fan Assembly (Continued)
3.7
Separate, untwist and unkink the two 80 " motor leads.
Route the two motor leads through the 4.5" downrod
(Figure 7).
3.8
Loosen the two Ph illi ps head setscrews in the motor
coupler for installation of the downrod (Figure 8).
Seat the downrod in the motor coupler (Figure 8).
Rotate and align the downrod holes with all the holes in
the motor coupler (Figure 8).
3.9
Align the clevis pin holes in the downrod with the holes
in the motor coupler.
Install the clevis pin and secure with the hairpin clip
(Figure 9).
The clevis pin must go through the holes in the motor
coupler. It is critical that the clevis pin in the motor
coupler is properly installed and securely tightened.
Evenly retighten the two Phillips head setscrews to
secure the downrod to the motor coupling in a vertical
position (Figure 9) .
.A. WARNING
It is critical that t he clevis pin a nd setscre ws in the motor
coupler are properly ins ta lled a nd securely tightened.
Fa ilure to verify that the pin and setscre ws are properly
in stalled could result in th e fan falling.
8
TWO 80" MOTOR LEADS (UNTWIS TED )
Fi g ure 7
LOOSEN
PHILLIPS HEAD
'
I
'
l
a,
'...,
'
SETSCREWS (, __: 2) ~iilll!I~~~
RP IN
p
EV IS
N
CLEVIS ~--
PIN
4.5" DOWNROD
4.5"
DOWNROD
MOTOR
COUPLING
~-~ HAIRPIN
I< CLIP
I