Owner Manual
3. Ceiling Fan Assembly (Continued)
3.5
NOTE: Installation
of
the blade will be complete
after this step:
Align
the
two
blade
tab
holes
of
one
blade
with
the
threaded holes of
the
motor and install a washer head
screw into each hole (Figure 5).
Loosely fasten each screw into the motor
ea
r. It will be
necessary push on the blade with
you
r hand
to
align the
ho
l
es
. Have patience during this step.
Repeat the washer head screw installation
to
r each of
the
remaini
ng
blades.
Fully tighten all six screws when
the
mating blade edges
are aligned and appear equally spaced.
NOTE: Installation of the three blade assemblies will
form the ceiling fan housing.
The
blades can be
adjusted by loosening the fifteen washer head screws
and repositioning
the
blades. Fully re-tighten all
fifteen screws when finished with adjustments.
3.6
NOTE:
If
using a longer accessory downrod, discard
the supplied 4.5" downrod and install the longer
downrod
(sold
separately)
using
the
following
instructions.
Remove the hanger ball by loosening the Phillips head
setscr
ew
in the hanger ball until the ball falls freely down
the 4.5" downrod (Figure 6).
Remove the pin from the 4.5" downrod, then remove the
hanger ball (Figure 6).
Re
tain
the
pin and
hange
r ball
for
reinstallation
in
Step 3
.1
2.
Note: Do
not
loosen the screw that attaches the
green ground wire
to
the hanger ball.
Figure
5
Figure
6
7
Bl.JI.DE
SCREWS
---~
(2
per
blade
r
assembly)
BLADE
ASSEMBLY
(3)
GREEN
GROUND
WIRE
4.
5"
DOWNROD
HANGER
BA
LL
PHILLIPS
HEAD
SET
SCREW
(LOOSENED)