Owner Manual

3. Ceiling Fan Assembly
3.1
Flip the upper foam pad over and place on a stable
wo rking surface.
Remove the tan motor assembly from the protective
plastic bag.
Place tan motor assembly on top of the foam pad with
the uppe r motor cover supporting the we ig ht of the
motor (Figure 1 ).
This will pe rmit access tor the blades to be installed.
3.2
Note: The blades will have screws installed from the
top and bottom into the motor assembly.
Carefully place the first blade onto the motor assembly
such that the large mounting flange with three holes aligns
with the three matching holes of the motor (Figure 2).
The two bottom blade mounting tabs should align with the
mating mounting ears on the other side of the motor.
Install three sc rews into the blade holes and loosely
fasten to the motor with a Phillips tip screwdriver.
Repeat this tor each of the other two blades. Be careful
to align the edge of each blade with the edge(s) of the
adjoining blades to avo id scratching the paint .
Reposition the blades as needed to fo rm a concentric
ci rcle with uniform gaps between the blades.
Aft er all thr ee blades are installed and aligned,
completely tighten the nine sc r ews . You may hea r a
popping noise as th e blade edges mate togethe r.
.A. WARNING
To reduce the risk of personal injury, do not bend the
blade assemblies when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between rotating fan blades.
5
Figure 1
Figure 2
UPPER MOTOR
COVER
~ _ _,,,.,,.,, WASHER HEAD SCREWS
T~ (3 per blade)
' BLADE (3)