Owner Manual

15. Light Kit LED Driver Replacement (Continued)
15.8
Squeeze and unclip the motor AC power connector from
the Light K it LED Driver connector (Figure 47).
Squeeze and unclip the motor DC powe r connector
from the Light Kit LED Driver connector (Figure 47).
15.9
Remove the two Phillips head screws from the Old Light
Kit LED Driver (Figure 48).
Retain the screws for future reinstallation.
Gently pull up on the Light Kit LED Driver. Remove the
Driver from the motor housing (Figure 48).
Discard the Old Light Kit LED Dr iver in the correct
recycle bin.
15.10
Place the New Light Kit LED Driver into the moto r
housing, aligning it directly where the Old Dri ver had
been (Figure 49).
I nstall the New Light Kit LED Dr iver to the moto r
hous i ng using the two screws previously removed
(Figure 49).
Fi g ure 47
~
~ VL_
30
LI GHT KIT L ED DR I VER
DC POWER CONNECTOR
REMOVE & RETA IN
PH I LL I PS HEAD
SCREWS (2 )
OLD LIGHT
KIT LED
DR I VER
MOTOR
HOUS I NG
REPLACE PH I LLIPS
HEAD SCREWS ( 2)
NEW LIGHT
KIT LED
DR I VER
MOTOR
HOUS I NG