Owner Manual

15. Light Kit LED Driver Replacement (Continued)
15.5
NOTE: You may need help of an assistant to hold
the ceiling cover, coupler cover and upper motor
cover up and away from the motor housing, while
performing the following steps.
Slide the motor coupler cover up the downrod to access
the top of the motor housing (Figure 44).
15.6
Remove the hairpin clip from the clevis pin. Remove the
clevis pin from the downrod (Figure 45).
Retain both the clevis pin and the hairpin clip for future
reinstallation.
Remove th e two setscrews, us i ng a Phi ll ips head
sc rewdriver, from the downrod (Figure 45).
Retain both setscrews for future reinstallation.
15.7
Remove the three upper motor cover screws, using a
Phillips head screwdr iv er (Figure 46).
Retain the three sc rews for future reinstallation.
Slide the upper motor cover up to expose access to the
light kit drive r.
29
4.5" DOWNROD
UPPER MOTOR
COVER
Figure 46
UPPER MOTOR
COVER
MOTOR
COUPLING
~/'H AIRPIN
IC- CLIP
0 UPPER MOTOR
COVER SCREWS (3)
v/