Owner Manual

14. Light Kit LED Array Assembly Replacement (Continued)
14.4
Disengage the fan motor assembly 2-pin wire connector
from the 2-pin wire connector of the Light Kit Assembly
(Figure 40).
14.5
I nstall new Li ght K it Assem b ly by following the
Section 5, Steps 5.2 through 5.4.
Restore electricity and verify function of the Light Ki t.
FAN MOTOR ASSEMBLY
2- PIN C ONNECTOR
LIGHT KIT ASSEMBLY --~
2-PIN CONNE C TOR
Figure 40
15. Light Kit LED Driver Replacement
The Light Kit Driver is located in the motor
assembly.
The entire ceiling fan will have to be unwired and
removed from the ceiling outlet box.
If you feel that you do not have enough electrical
wiring knowledge or experience, contact a licensed
electrician to complete this repair.
15.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to remove
the ceiling fan from the mounting bracket.
Tools Needed
One Phillips head screwdriver
One stepladder
27
-4. WARNING
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock .
-4. WARNING
To avoid possible electrical shock, be sure elec t ricity
is turned off at the main fuse box before wiring .
NOTE: If you are not sure if the outlet box is grounded ,
contact a licensed electrician for advice, as it must be
grounded for safe operation.