Owner Manual
9.
Programming the Receiver Operating Frequency
& High Speed Conditioning of Fan Control
-- Important - Read This Section Carefully and Follow
the
High Speed Conditioning Instructions Closely --
PROGRAMMING
THE
RECEIVER
OPERATING FREQUENCY & HIGH SPEED
CONDITIONING
OF
FAN CONTROL
IMPORTANT: Ceiling fan blades
.M.U.fil
be installed
before high speed conditioning can begin.
NOTE:
If
using a 3-way switch installation, ensure
that both wall controls
ar
e using the same switch
code.
9.1
Turn
the
wall
switch
ON/OFF
switch
to
the
"OFF"
position.
Restore electricity
to
the
ceiling fan branch circuit at the
circuit breaker or fuse box
Flip the wall control's ON/OFF switch
to
"ON" position.
Within one minute of flipping the switch
to
"ON", push
and hold the FAN OFF button (@ )
for
3 to 5 seconds to
set
the
code
in
the
receive
r.
The
ceiling
fan
lights
(if installed) will bli
nk
to
indicate
the
wall control code
has been paired with
the
receive
r.
IMPORTANT: Immediately after successful pairing,
the ceiling fan will automatically begin high speed
conditioning
of
the motor. During conditioning, the
electronic
motor
control
software
is
calculat
ing
speeds
for
the
2nd
through
5th
speed
settings
based on the blades that were installed on the fan.
The
fan
will run
for
approximately
1
minute
in
the
upwa
rd direction then rever
se
direction to down flow
and
run
an additional 1 minute. When conditioning is
complete, the fan will come
to
complete stop.
IMPORTANT: Do not interrupt the conditioning until
the fan comes to a complete stop in approximately
3
minutes
.
All
functions
of
the
control
will
be
reje
ct
ed during conditioning.
High speed conditioning is now complete.
23
9.2
If
prog
r
amming
is
unsuccessful,
r
etry
the
previous
instructions after cycling the wall control ON
/O
FF switch
to
restart the 1 minute programming time peri
od
.
If still unsuccessful,
shut
off the electricity
at
the fuse
box
or
breaker
panel
and
change
the
wall
control
frequency (Section 8.
3,
Page 18).
Afte
r
changing
the
fr
equency
settings,
repeat
instructions in Section 9
.1
within one minute
of
restoring
the electricity.