Owner Manual
8. Wall Control Installation (Continued)
8.5
This control is designed
to
operate only one ceiling fan
NOTE:
Electric
connections
should
be
in
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect power
to
the
circuit
at
the
fuse
box
or
circuit
breaker
panel.
Remove the faceplate and screws from the existing wall
switch. Pull switch out from wall outlet
box
.
Dete
r
mi
ne
the
"hot"
wire
and
the
"load"
wi
re
and
disconnect
these
wires
from
existing
control
(Figure 32).
Do
not
attempt
to
disconnect
any
wir
es
not already
connected
to
existing control.
Skip to Section 8. 7 if using a 3-way switch
installation.
SINGLE-POLE INSTALLATION
8.6
Disconnect electrical power to
the
branch circuit at the
ci
rcuit breaker or fuse box before attempting to install
the ceiling fan wall control into
the
outlet box.
Before installing wall control, place wall control in "OFF"
mode
by
pushing
"O
N
/OFF"
sw
i
tch
to
the
"OFF"
Do
not connect any neutral (white) wire to this control.
In
correct wiring will damage this control.
position.
Connect one black wire
of
wall control to the "hot" wire.
Securely connect wires with wire connectors supplied
(Figure 33).
Connect
one
black
wire
of
wall
switch
to
the "load"
(black) wire
in
wall
box
. Securely connect wires with
wire connector supplied.
.A.
WARNING
Check to see that all connections are tight and that
no
bare wires are visible at the wire connectors.
19
FACEPLATE
Figure
32
Screw
wall control
into
wall
box
us
i
ng
the
supplied
screws. Leave wall control
in
"OFF"
mode
until fan
installation is completed.
The
wall control
is
supplied with a white, ivory, and
almond col
or
switch covers. Choose the finish that best
suits
your
needs
and
snap
the
cove
r on
to
the wall
control (Figure 33).
I
nstall
decorator
wall
plate
using
the
two
screws
provided with wall plate. Leave wall control in "OFF"
mode until fan installation
is
completed (Figure 33).
SCREWS
(2)
D
0
FAN
/LI
GHT
WALL
CONTROL
SWITCH
COVER
DECORATIVE
WALL
PLATE
Figur
e
33
WALL
BOX