Owner Manual

6. Optional Installation No-Light Plate Assembly (Continued)
6.3
Disengage the fan motor assembly 2-pin wire connector
from the 2-pin wire connector of the Light Kit Assembly
(Figure 23).
Store Light Kit Assembly in a safe location for future
installation.
Reinstall the #6- 32 x . 375 " pan head sc r ew into the
Light Kit Adapter.
Secur ely tighten the th r ee #6-32 x . 375 " pan head
screws.
A spare Light Kit Assembly #6-32 x .375" pan head
screw is in the parts bag, if needed.
6.4
Carefully tuck all the wir es and connector into the Light
Kit Adapte r.
Place the no -light plate into the opening of the Light Kit
Adapter, aligning the three flat areas on the top edge of
the no-light plate with the three raised dimples on the
Light Kit Adapter and turn the plate clockwi se until it
stops (Figure 24).
NOTE: The no-light plate is equipped with an
interference device that will not allow it to be
installed if the light kit assembly is not removed.
NOTE: Periodically check that the no-light plate is
seated fully clockwise in Light Kit Adapter.
14
REINSTALL UGH
KIT ADAPTER PA
HEAD SCREW
F AN MOTOR ASSEMBLY
2-PIN C ONNECTOR
LIGHT KIT ASSEMBLY --~
2-PIN CONNECTOR
Figure 23
t #
RO TATE CLOCKWISE
Figure 24
LIGH T KI T
ADAP TER
RAISED
DIMPLES (3)
NO-LIGHT PLATE
FLAT AREA OF NO-LIGHT
PLATE (3)