Owner Manual

5. Light Kit Assembly (Continued)
5.4
Place the shade into the open i ng of the Li ght Kit
Adapter, aligning the three flat areas on the top edge of
the shade with the three raised dimples on the Li ght Kit
Adapter and turn the shade clockwise until it stops
(Figure 20).
NOTE: Periodically check that the shade is seated
fully clockwise in the Light Kit Adapter.
Figure 20
4i ,,,
ROTATE
CLOCKWISE
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
SHADE
FLAT AREA OF
SHADE (3)
6. Optional Installation of No-Light Plate Assembly
Skip to Section 6.4 if supplied light kit is
not already installed.
6.1
Removal of the Shade from the Light Kit Adapter:
Rotate the Shade counter-clockwise to loosen from the
Light Kit Adapter (Figure 21 ).
Remove the Shade from the Light K it Adapter
(Figure 21 ).
Store Shade in a safe location for future installation.
6.2
Removal of the Light Kit Assembly from the Light
Kit Adapter:
Loosened the Light Kit Adapter #6-32 x .375" two pan
head screws located in the key hole slots.
Remove the remaining Light Kit Adapter #6-32 x .375"
pan head screw (Figure 22). Retain fo r future use.
Rotate the Light Kit Assembly counter-clockwise to
disengage the two screw heads in the key hole slots for
removal of Light Kit Assembly.
13
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
SHADE
"'tns t
FLAT AREA OF
Figure 21
ROTATE COUNTER ·
CLOCKWISE
....._____
\.
S HADE (3)
LOOSENED LIGHT KIT ADAPTER
PAN HEAD SCREWS (2)
LIGHT KIT
ADAPTER
; -
h ROTATE COUNTER·
LIGHT KIT
ASSEMBL Y
Figure 22
"""' • ~ CLOCKW I SE
LIGHT KIT ADAP TER
P AN HEAD SC R EW (1)