Installation & Assembly

Step 3
Step 4
With the chair bottom up, place the seat surface on a flat table
top as shown in picture 1 .
Insert each front leg completely vertically into each seat frame
corner,PRESS FIRMLY DOWN with your hand until there is no
gap between the front leg and the seat cushion.
WARNING!! DO NOT POSITION THE FRONT LEG AS
SHOWN IN PICTURE 2 ,WHICH SHOWS THE CHAIR BACK
STAYS AGAINST THE GROUND AND THE FRONT LEGS
LIES horizontally.
Now tighten the bottom bolt at first, then the blot on the top by
using pack B with your hands, please do not tighten the top bolt
first.
WARNING!! DO NOT OVER TIGHTEN. OVER TIGHTENING
COULD LEAD TO DAMAGE OF THE PRODUCT. TIGHTEN
ONLY UNTIL SECURE AND STABLE.
If wobble
Test again
30cm 50cm
Page 5 OF 6