Installation & Assembly

Step 1

Chair Back

Step 2

Put the chair back( A) onto a flat table or panel,align the

positioning dowels on the chair seat with the holes located on

the chair back-panel and chair-seat panel.

Use your left hand to push the seat frame bottom horizontally

forwards and hold it for ensuring the chair seat is vertical to the

chair back without gap between them.

With your right hand,lock the middle hole & the corner holes by

using "PACK A" hardware with an Allen key provided.

WARNING !! DO NOT OVER TIGHTEN. OVER TIGHTENING

COULD LEAD TO DAMAGE OF THE PRODUCT. TIGHTEN

ONLY UNTIL SECURE.

Chair Seat

Place the chair back(A) on a soft surface to avoid any scratches

or damages to the product.

REMOVE the non-woven fabric from under the chair seat, take

out the front legs and hardware.

Page 4 OF 6