Product Manual

18
Storing
Allow engine to cool before inspecting and storing
1. Inspect for worn or damaged parts
2. Choose a covered storage location
3. Start engine every 4 weeks;
-OR-
4. Prepare engine for long-term (seasonal) storage if needed.
1. Inspect for worn or damaged parts:
Inspect the Hydraulic Power Pack for worn or damaged parts and tighten any nuts or screws that may have
become loose. Check for any fuel or hydraulic system leaks.
2. Choose a covered storage location:
Store the Hydraulic Power Pack in a location that is:
• Clean and dry.
• Away from sources of heat, open flames, sparks, and pilot lights, even if the gas tank is empty.
(Residual gasoline fumes can still ignite)
• Away from extreme high or low temperatures.
• Cover for extra protection.
WARNING: Stored Gasoline Vapor Fire Hazard
Gasoline is highly flammable and explosive. Drain the fuel into an approved container OUTDOORS and far
away from open flame.
NEVER store an engine with fuel in the tank indoors or in poorly ventilated spaces where fuel vapor can come in
contact with:
Static electric sparks;
Sparks from electric wiring, batteries, or running engines;
Sources of heat (such as hot engine or exhaust);
Open flames, including pilot lights.
3. Start engine every 4 weeks:
For future easy starting and to minimize maintenance requirements, the Hydraulic Power Pack should be
started at least every four weeks and run for 10 to 15 minutes.
Monthly exercising of the engine will dry out any moisture that has accumulated, lubricate cylinders, and clean
out old gas in the carburetor. Moisture, old gas, and dry mechanical parts cause deterioration in stored engines.
CAUTION: HBHS users without installed directional control valve
If the unit is not equipped with a directional control valve, please ensure the power unit is properly plumbed to
the powered equipment prior to attempting to start the engine. Unit cannot be run without implement attached.
Damage to engine or hydraulic components can occur.