Product Manual
Table Of Contents
- NOTICE TO OPERATORS
- CAUTION
- OPERATOR INSTRUCTIONAL DATA SHEET
- 1 INTRODUCTION
- 2 INTENDED USE
- 3 TRAINING
- 4 SAFETY SYMBOLS
- 5 SAFETY INSTRUCTIONS
- Clothing
- Flying Debris
- Burns
- BACK CARE & PROPER LIFTING PROCEDURES
- Back Anatomy
- Back Care Preventative Measures
- PROPER LIFTING PROCEDURES
- TRANSPORTATION
- DETERMINATION OF POTENTIAL SUBSURFACE HAZARDS IN PROPOSED DIGGING LOCATION(S)
- DETERMINATION OF POTENTIAL ABOVE SURFACE HAZARDS IN PROPOSED DIGGING LOCATION(S)
- OPERATIONAL HAZARDS UNDERSTANDING KICKBACK
- MINIMIZING KICKBACK FROM A DESIGN STANDPOINT
- 6 MACHINE SPECIFICATIONS
- 7 STANDARD PRODUCT & ACCESSORIES
- 8 MACHINE SET-UP
- 9 APPLICATION THEORY & TECHNIQUES
- 10 OPERATING INSTRUCTIONS
- 11 MAINTENANCE INSTRUCTIONS
- 12 SERVICE/REPAIR INSTRUCTIONS
- 13 TROUBLESHOOTING
- NOTE: If troubleshooting information does not correct situation, all maintenance/repairs not described in this operator manual must be done by a dedicated service center following a specific service/repair manual.
- ENGINE WILL NOT START
- ENGINE LOSES POWER
- ENGINE OVERHEATS
- AUGER LACKS POWER
- AUGER BIT ROTATES AT IDLE SPEED
- TEMPORARY STORAGE (On Job Site)
- LONG TERM STORAGE
- 15 END OF LIFECYCLE
