User manual

-16-
If you forget to turn off or exit WIFI or when the camera is
disconnected from mobile phone, and reaches the camera
default "auto shutdown wifi" time, the camera will exit WIFI
automatically and return to “ON” mode or “SETUP” mode.
7. Working Mode Description
1. Calibrate the installation position of camera
In the “SETUP” mode, the best shooting angle and range of the
camera can be adjusted.
During calibration, you can choose whether to use the side
sensor for observation. The steps to calibrate the camera
position are as follows:
Tie the camera to a tree or an object 1~2 meter high, adjust the
camera lens direction, and then slowly move the camera to the
other side to monitor the motion track.
If the side PIR indicator is on, it means that the side sensor has
detected the moving object. If the main PIR indicator is on, it
means that the main sensor has detected the moving object. In
this way, the best position for installing the camera can be found.
The indicator light will be on only when the sensor detects
moving objects in the “SETUP” mode and off in the “ON” mode.
Make sure that the camera will not be interfered unnecessarily
when it is working, and avoid direct sunlight or near the
branches.
2. Normal operation mode
In this mode, the camera is triggered to shot by the sensor; the
camera enters monitoring mode when the switch is “ON”. After 5
seconds, the LED lights will turn off and the camera starts to
operate independently and enter the standby mode. Once an
animal enters the area detected by the side sensor, the camera
will be activated and detect the motion track. If the animal