User manual

3 Cutter block

4 Twistable trimmer

4a Wide trimmer (28 mm)

4b Narrow trimmer (14 mm)

5 Charging light

6 On/off switch

7 Adjustable comb

8 Beard length selector

9 Special cord set

10 Precision comb

11 Charging stand

Charging

Recommended ambient temperature for charging is 5 °C to 35 °C.

The battery may not charge properly or at all under extreme low or high

temperatures. Recommended ambient temperature for shaving is 15 °C to

35 °C. Do not expose the shaver to temperatures higher than 50 °C for

extended periods of time.

• Using the special cord set, connect the shaver to an electrical outlet with

the motor switched off.

• When charging for the first time or when the shaver is not used for a few

months, leave the shaver to charge continuously for 4 hours.

• The charging light (5) shows that the appliance is being charged. When the

battery is fully charged, the charging light turns off. Intermittent blinking

after a while indicates that the battery maintains its full capacity. This can

also happen short term when charging after the battery was completely

discharged.

• A full charge provides 30 minutes of cordless shaving time depending on

your beard growth.

• Once the shaver is completely charged, discharge the shaver through

normal use. Then recharge to full capacity. Subsequent charges will take

about 1 hour.

• Maximum battery capacity will only be reached after several charging/

discharging cycles.

• 5-minute quick charge is sufficient for a shave.

Shaving

First, remove the adjustable comb (7): Using your thumbs, press against the

side clips of the adjustable comb so that they swing off in the direction of the

97144063_cruzer6_face_MN_S6-84.indd 1397144063_cruzer6_face_MN_S6-84.indd 13 23.09.14 11:2223.09.14 11:22

CSS APPROVED Effective Date 26Sep2014 GMT - Printed 01Oct2015 Page 13 of 84