Owner's manual

C Clean&Renew

Braun Clean&Renew has been developed for cleaning, charging and storing

your shaver.

Clean your shaver daily in the Clean&Renew.

During the automated cleaning process, the shaver is switched on and off

at intervals to obtain best cleaning results. Since the specially formulated

cleaning fluid contains a small amount of oil, the cleaning procedure also

fulfils the lubrication needs of the shaver.

Important

• Only use the power supply special electric cord set supplied with the shaver.

• In order to avoid any leakage of the cleaning fluid, place the appliance on a

flat, stable surface. Do not tip, move suddenly or transport in any way if a

cleaning cartridge is installed.

• Do not place the appliance in a mirror cabinet, nor store it over radiators,

nor place it on polished or lacquered surfaces. Do not expose to direct

sunlight.

• The appliance contains flammable liquid. Keep it away from

sources of ignition. No smoking.

• Keep out of reach of children. Do not refill cartridge. Use only

original Braun refill cartridge.

Description

1 Start/release button

2 Contact bow

3 Lift button for cartridge exchange

4 Level indicator

5 Cleaning cartridge

Before using Clean&Renew

Installing the cartridge

• Press the lift button (3) to open the housing.

• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully

remove the lid from the cartridge. Slide the cartridge into the base as far as

it will go.

• Slowly close the housing by pushing it down until it locks.

Replacing the cartridge

After having pressed the lift button (3) to open the housing, wait for a few

seconds before removing the used cartridge.

99778043_Floater390cc4_NA_S6-.indd 1199778043_Floater390cc4_NA_S6-.indd 11 26.01.11 10:4126.01.11 10:41