Operation Manual

ENGLISH

b. Open the  lm holder by pulling down on the tab

from the bottom center of the holder. Lift the front

part of the holder. The top side of the holder

is marked with white arrows.

Loading 135  lm into the holder

a. Orient  lm strip based on

the example graphic “abc”

on the holder.

135  lm holder

abc

Pull

down

White arrows

Lift

open

e. Insert the  lm holder into the scanner from the left or right side into the

small opening. Push the holder inside until you feel it hit a stop, then scan.

After the scan is done, push the holder farther into the scanner until it hits

another stop, and scan again. Repeat until the end of the holder.

Make sure that the orientation of white arrows on the holder correspond

with the triangle mark on the scanner.

c. lnsert the orientated  lm negative into the holder between the

horizontal guides. Carefully line up the dividers on the  lm negative with

the dividers on the holder.

Loading 135  lm into the holder (continued)

Horizontal

guides

Dividers

d. Close the holder and push the tab to the closed position.

Push to closed

position

Insert the  lm holder