Specifications

Creating Your First Label Chapter 5-3
Figure 5-2 Select Printer
3 Do one of the following:
• If you previously installed a thermal/thermal transfer
printer driver for use with this label design program,
click the Printer drop-down arrow and select your
printer from the list of installed printers.
• If you have not yet installed a thermal/thermal trans-
fer printer driver for use with this label design pro-
gram, click Install, select your printer’s manufacturer
and model, and again click Install. The new printer
will be copied to the Installed Printers list. Click
Close.
4 Click OK.
Label Setup When you start the program, a default label appears ready for
you to design. The label width, height, margins, and other
general setup options can be changed using the Label Setup
tabs.
 To set the units of measure for the label:
1 On the Options menu, click Configuration, and then
click the Display tab.
2 In the Units box, click inches.
3 Click OK.
 To set up the label:
1 On the Edit menu, click Label Setup.
The Label Setup tabs appear.