Instructions / Assembly

Step 5 - Check for Leaks
Open valve in water line. Turn faucet on (hold if
necessary) to fill tank (about 1 minute). When tank is
full, water will flow from faucet. Turn faucet off. Check
for leaks.
Step 6 - Prepare for Power
Double check thermostat control dial is in the
OFF position. Thermostat control dial controls the
water temperature, not the water flow or
delivery.
IMPORTANT INFORMATION - This dispenser is equipped with a Self Re-setting Thermal Fuse
Turn thermostat to OFF position and fill tank with water before plugging the power cord from the
tank into an electrical outlet
If tank is empty and the thermostat set in the ON position when the power cord is connected, the
self re-setting fuse in the heater control will disconnect the current to the heater after approximately
one minute, thus protecting the heater from a "dry start” failure. The fuse in the heater control will
self-reset after approximately
1
/2 hour*. Turn on the water supply to the tank and continue the
installation.
Continued misuse will cause damage to the appliance and is detectible thus, voiding the warranty.
*(Re-setting of fuse can be accelerated by turning on the water supply and dispensing water until
use re-sets, approximately 3 minutes.)
Step 7 - Test Installation
Plug electrical cord into a grounded 3-prong outlet.
Do not use an outlet controlled by an off/on wall switch. Turn thermostat control dial clockwise to the
highest position. Maximum temperature will be reached in about 15 minutes and dispenser will be ready
for use. Lower the temperature setting by turning thermostat control dial counterclockwise if you notice
vapor or a boiling noise. To raise or lower the water temperature, rotate the thermostat dial. At the LOW
setting of thermostat dial water temperature will be approximately 140°F (60°C) and at the HIGH setting
of the thermostat dial water temperature will be approximately 200°F (93°C).
open
place bucket under valve in case
of of any leaking