Specifications

S83/85 Ultrasonic Generator System Installation
A40-064 Rev 0 Page 65
5.10.2 Mounting an SB Type Immersible Transducer
Figure 5-29 Mounting an SB Type Immersible Transducer
transducer
SB−type immersible
(SB618 shown)
junction box
Tank wall
12" on
center
Step Action
1 Select a location on the tank all for the immersible transducer.
2 Measure and mark the locations for the mounting hole(s) (Figure
5-28 and Figure 5-29)
3 Secure the immersible transducer to the tank wall (as shown in
Figure 5-29) as follows:
a. Attach the washer and jam nut to the fitting and
tighten.
b. Route the fitting with the wires through the hole in
the tank and through the hole of the EB/SB
junction box.
c. Attach the washer and jam nut to the fitting, and
tighten.
4 Connect the wires to the incoming RF cable or jumper from another
immersible transducer. Follow the wiring instructions below.