Specifications

14
JACKING UP THE CAR
▪ The use of wheel chocks or blocks is required when jacking up the car.
▪ Jack stand locations are suitable for full lift and single end elevated requirements.
▪ Use care to not damage the radiator or after cooler radiator when positioning jack.
▪ Use rags or cardboard between the jack and the frame, as well as between the jack stands and frame,
to avoid scratching the frame’s finish.
Procedures:
1. Position the floor jack directly under the front lower A-arm bushing bracket.
2. Locate the jack stands on right and left sides of car directly under the longitudal tube of lower chassis.
3. Locate one of the jack stands directly under the rear bottom cross member as far to the left side as
possible.
4. Position the floor jack directly under the rear bottom cross member at the centerline of car.
5. Locate one of the jack stands directly under the rear bottom cross member as far to the right side as
possible.
Never get under your vehicle when it is only supported by a jack.