Installation Guide
Table Of Contents
- Outdoor/Indoor Drawer Refrigerator/Freezer BR-24FZREF
- OWNER’S MANUAL
- A PROUD HERITAGE OF EXPERIENCE & QUALITY
- PRODUCT REGISTRATION
- GENERAL OPERATING INSTRUCTIONS
- TABLE OF CONTENTS
- IMPORTANT SAFETY INSTRUCTIONS
- ELECTRICAL CONNECTION
- PARTS AND SPECIFICATIONS
- INSTALLATION
- OPERATING YOUR APPLIANCE
- CARE AND MAINTENANCE
- PROBLEMS WITH YOUR APPLIANCE
- TERMS OF SALE AND WARRANTY
- SERVICE & IMPORTANT NOTICE
8
W W W . V I N O T E M P . C O M
8
INSTALLATION
• Remove all packing material before using your appliance.
• IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water and a soft cloth.
• This unit is designed for freestanding or built in installation and indoor or outdoor use. Position the unit in
a dry and well-ventilated place. Avoid placing the unit near any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below 44°F.
• For freestanding installation, 5 inches of space between the back and sides of the unit are suggested,
which allows the proper air circulation to cool the compressor and condenser for energy saving. Even for
built-in installation, it is a must to keep ¼” space on each side and at the top to ensure proper service
access and ventilation. And the air vent at the front of the appliance must never be covered or blocked in
any way.
• Place the unit on a level surface strong enough to support it when it is fully loaded. To level the appliance,
adjust the front leveling legs at the bottom of the appliance.
• For best performance it is recommended that you install the appliance in a location with an ambient
temperature between 44°-106°F. If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected.
Anti-tip Bracket Installation
To reduce the risk of tipping the unit by abnormal usage or improper loading, the appliance must be secured
by properly installing the anti-tip device packed with the appliance.
• Place the anti-tip bracket on the floor as shown in the figure. An anti-tip bracket must be installed at the
left side.
• Mark the locations of the 4 holes of the anti-tip bracket on the floor.
• Use a 5/16” masonry drill bit and insert plastic anchors.
• Secure bracket to floor using screws.
• Slide appliance into position and make sure the leg engages the anti-tip bracket.
NOTE: If the unit is relocated, the bracket must be removed and installed in the new location.