Installation Guide

14
W W W . V I N O T E M P . C O M
14
PROBLEM
POSSIBLE CAUSE
REMEDY
The appliance seems to make
too much noise.
• There is a rattling noise.
• There are gurgling sounds.
• There are popping and
cracking noises.
The appliance is not properly
leveled.
• This noise may be caused by
the internal flow of the
refrigerant. This is normal.
• As each cycle ends, these
sounds may be caused by the
flow of refrigerant in the
appliance.
• These sounds are usually
caused by internal
temperature fluctuations. It is
due to the contraction and
expansion of the interior walls.
Level the appliance with the
adjustable feet.
The door will not close properly.
• The appliance is not properly
level.
• The door was reversed and
not properly installed.
• The gasket is dirty.
The shelves are out of position.
• Level the appliance with the
adjustable feet.
• Check the door hinge and
reassemble correctly.
• Clean the door gasket.
Check the shelves and refit
correctly.
The alarm sounds and the
temperature display flashes.
• Has the appliance door been
open for longer than 60
seconds? If not, then the
temperature has risen higher or
fallen lower than the
temperature that has been set.
This could be due to:
• The appliance door being
opened too often.
• The ventilation opening being
covered or too dusty.
• A lengthy interruption to the
power supply.
A large amount of bottles has
been added to the unit.
• If yes, close the door.
• Do not open the door more
often than necessary.
• Clear the obstructions and
clean the dust.
Leave the appliance to work for a
while until the set temperature
has been reached.
The icon “--” is lit and flashing in
the temperature display.
The display temperature is out of
range.
Only temperatures within the
range 0~99°F/-9~37°C can be
displayed. If the temperature is
not within this range, the icon “--”
will be displayed instead. This is
normal.