Specifications

19
WALL CONTROL FUNCTIONS
Timed Automatic Stop
Using The Cooler
30
ILL1137-A
You can also set the cooler to turn off after
a set number of hours.
1. To set a delayed stop time, press TIMER
with the cooler running. "Stopping in" will
display.
2. Press
S or T to adjust the number of
hours before the cooler will stop. The
maximum delay setting is 24 hours.
3. Press TIMER again to begin timed stop.
Now that you have read these instructions, press the POWER button to turn your
cooler on. If the cooler has not operated for a while "Pre Cool Cycle" will flash on
the display. The "Pre Cool Cycle" will begin and will take only a few moments to
complete. After this time, the fan will come on automatically, and you can enjoy
the comfort of cool fresh air.
Air Too Cold
With the cooler running in automatic mode, you may find that you are too cold or
that the cooler is blowing too much air. Press T to lower the automatic
temperature setting and reduce the amount of cooling.
If you are to cold with the cooler running in Manual mode, then press T to reduce
the fan sped. You can also circulate uncooled fresh air by pressing COOL until
"Vent" displays.
Air Not Cold Enough
You may find that with the cooler running in Automatic mode, that you are not cool
enough. Simply press S to increase the cooling rate.
If you are not cool enough with the cooler running in Manual mode, then press S
to increase the fan speed. Ensure that cooled air is circulating by pressing COOL
until "Cool" is displayed.