Specifications

DL700 Holter Monitor
3
Patient Event Button
Patients should be instructed to use this Event Button anytime they feel
symptoms similar to those which they have been instructed by their
physician to note in their Patient Log along with date and time information.
Figure 1
DL700 Holter Recorder
Patient Input Connector
The patient input connector provides a snug and reliable connection for the
patient electrode leads along with complete color-coding for each lead.
Test Jacks
Three test jacks are provided to verify that a good, reliable signal is being
obtained on each ECG channel immediately after connecting the electrodes
to the patient. This test should be done prior to allowing the patient to leave
the clinic.
DL700 Holter Monitor
4
Gain Switch
A gain switch is provided to allow the medical technician to adjust signal
amplitude. Three positions are provided: 1/2X, 1X, and 2X. Position
indications are on the label above the switch.
Operating LED
This is the green LED just to the right of the gain switch (Fig 1). It provides
current status information on the recorder (See Operation Section).
Equipment Symbols
Symbol Description
Type B equipment.
Consult manual.
0086
Complies with the Medical Device Directive of
the European Union.
Waste Electrical and Electronic Equipment
(WEEE) It is the responsibility of the end user
to dispose of this equipment at a designated
collection point for recycling.
Year of Manufacture
SN
Serial Number
REF
Not shown - DL700 is the catalogue number.
European Representative:
CEpartner4U BV
Esdoornlaan 13
3951 DB Maarn.
The Netherlands
Tel: [phone]