Specification Sheet

The



brighter



choice

Braeburn Round

Zone Dampers

Power Close,

Spring Return

Braeburn Motorized Round Zone Dampers

are used to control the volume of air that will be

distributed to a zone area. With easy two wire

installation and a stall and backlash protected

motor, our zone dampers provide the quality and

durability you have come to expect from Braeburn.

Quick and Easy Installation

Braeburn power close spring return dampers were

designed and built to ensure easy installation and

years of trouble free use. Each damper is formed

from heavy duty galvanized steel.

Product Features and Beneﬁts

• Power Close Spring Return with Power Fail

Open Operation

• Long life Full Stall Capable Motor Provides

Years of Trouble Free Operation

• Virtually Silent Clock Drive Motor

• Heavy Duty Galvanized Construction with

Precision Rolled Stiffening Ribs

Speciﬁcations

Dimensions See dimensional drawing on reverse

Power 24 VAC 8 VA

Actuator Clock Drive with Backlash Protection,

Power Close, Spring Return

Connection Two Wire Leads

Toll-Free 866.268.5599 (U.S.) +1.630.844.1968 (Outside the U.S.) www.braeburnonline.com

PAGE 1
Power Close, Spring Return Braeburn Round Zone Dampers Braeburn Motorized Round Zone Dampers are used to control the volume of air that will be distributed to a zone area. With easy two wire installation and a stall and backlash protected motor, our zone dampers provide the quality and durability you have come to expect from Braeburn. Quick and Easy Installation Braeburn power close spring return dampers were designed and built to ensure easy installation and years of trouble free use.
PAGE 2
Braeburn Round Zone Dampers Power Close, Spring Return Architectural Specifications The Round Power Close / Spring Return Damper shall be Braeburn Series 1190XX where XX indicates damper diameter (04, 05, 06, 07, 08, 09, 10, 12, 14, 16, 18 and 20 inches). The damper shall be powered directly from zone panel 24 VAC damper terminals. A common wire along with a power close wire shall be provided for damper control. In the event of a power failure, no readjustment shall be required.