Wireless Setup Guide TM Model 7500 Universal Programmable Wireless Thermostat Kit Leave this Setup Guide with thermostat.
1 Getting Started 1.1 Install and wire the control module to the HVAC equipment (see Installer Guide, Section 2, Part 1). 1.2 Install 2 supplied AA batteries into the thermostat (See Installer Guide, Section 2, Part 4). NOTE: Thermostat can be battery powered or 24 VAC powered (hardwired). If multiple wireless remote sensors are used, it is recommended to hardwire the thermostat.
2 Pair the Thermostat and Control Module 2.1 On the thermostat, press and hold down the HOLD and RETURN buttons for 3 seconds. 2.2 The word CMOD (control module) will appear in the display and the will flash (see Figure 1). symbol NOTE: If the control module has already been paired, the symbol will not be flashing. To reset wireless connection to control module, see Installer Guide, Section 4.
2.3 On the powered control module, press and hold the CONNECT button for 3 seconds (see Figure 2). 2.4 The control module will enter pairing mode for 60 seconds. During this time the blue COMM indicator on the control module will flash once every 2 seconds. 2.5 Once successfully paired, the symbol will stop flashing and the blue COMM indicator on the control module will turn on. 2.6 Press RETURN on the thermostat at any time to exit.
3 Complete Installation 3.1 Mount the thermostat (see Installer Guide, Section 2, Parts 2-5). 3.2 If applicable, install and connect any wireless remote accessories (see Accessory Manual). 3.3 Configure Thermostat Installer Settings based on your particular application (see Installer Guide, Section 4). 3.4 If desired, adjust User Settings, Time of Day and Program Schedule (see User Manual). 3.5 Test system (see Installer Guide, Section 6).
® Braeburn Systems LLC 2215 Cornell Avenue • Montgomery, IL 60538 Technical Assistance: www.braeburnonline.com 844-BLU-LINK (844-258-5465) (U.S.) 630-844-1968 (Outside the U.S.) ©2015 Braeburn Systems LLC • All Rights Reserved • Made in China.
