Install Instructions

Fan Stage(s) Test ON or OFF
This test turns on all fan stages and commands all dampers
to open. Press SELECT to test or NEXT to advance to the next test.
Operation
6
The Zone Panel has LED’s and a built-in display to tell the installer
and the system owner the current operating mode of the panel.
Refer to the figure below and the following descriptions of the
panel LED’s for operation information.
Damper Control Test PO or PC
This test powers all dampers open or closed. Press SELECT to test
or NEXT to advance to return to first test.
LED COLOR INDICATION
Panel Status LED
Panel Power Green Flashing Green When Normal
Equipment LED’s
Rh Red 24 VAC at equipment Rh Terminal
Rc Red 24 VAC at equipment Rc Terminal
Y1 Yellow First Stage Compressor Call Active
Y2 Yellow Second Stage Compressor Call Active
G Green First Stage Fan Call Active
G2 Green Second Stage Fan Call Active
W1/E/AUX White W1, E or AUX Call Active
W2/O/B White W2 or Reversing Valve Call Active
L Yellow Input from Equipment Check is Active
14
(continued)