User's Manual

Installer Guide 4
1 HEAT / 1 COOL Single or Dual Transformer
Set System Type to 11CONV
Rh 7PMU"$1PXFSIFBUJOHUSBOTGPSNFS[note 2]
Rc 7PMU"$1PXFSDPPMJOHUSBOTGPSNFS[note 2]
W1 )FBU3FMBZ
Y1 $PNQSFTTPS3FMBZ
G 'BO3FMBZ
C 7PMU"$5SBOTGPSNFS$PNNPO[note 1, 3]
NOTES - Conventional Systems
[1]0QUJPOBM7PMU"$DPNNPODPOOFDUJPO
 SFRVJSFEGPS8J'J
[2]3FNPWFGBDUPSZJOTUBMMFEKVNQFSGPSEVBM
 USBOTGPSNFSTZTUFNT
[3]*OEVBMUSBOTGPSNFSTZTUFNTUSBOTGPSNFS
 DPNNPONVTUDPNFGSPNDPPMJOHUSBOTGPSNFS
[4]*GOFFEFEGPSTZTUFN
Provide disconnect and overload protection
as required.
2 HEAT / 2 COOL Single or Dual transformer
Set System Type to 22CONV
Rh 7PMU"$1PXFSIFBUJOHUSBOTGPSNFS[note 2]
Rc 7PMU"$1PXFSDPPMJOHUSBOTGPSNFS[note 2]
W1 )FBU3FMBZ4UBHF
W2 )FBU3FMBZ4UBHF
Y1 $PNQSFTTPS3FMBZ4UBHF
Y2 $PNQSFTTPS3FMBZ4UBHF [note 4]
G 'BO3FMBZ
C 7PMU"$5SBOTGPSNFS$PNNPO[note 1, 3]
5ZQJDBM8JSJOH$POmHVSBUJPOT
NOTE: The “System Type” option will be configured in the Installer Settings section.
Conventional Systems
Heat Only
Set System Type to 11CONV
Rh 7PMU"$1PXFS
W1 )FBU3FMBZ
G 'BO3FMBZ[note 4]
C 7PMU"$5SBOTGPSNFS$PNNPO[note 1]