User`s guide

Error Message Cause Corrective Action
Head Too Hot Print head cannot
reliably print due to heat
buildup.
1. Press the <Enter> or <Delete>
button to clear the display.
2. Allow the printer to cool for ten
minutes before printing labels.
The marker roll may be
running through the
printer twice.
The smart cell is programmed to run 125%
of the total number of markers on the roll
and then stop. Insert a new marker roll and
continue.
Invalid Label
Smart cell may not be
programmed properly.
Contact BRADY’s Technical Support
Group.
Battery pack is not
charged.
1. Connect the battery charger to the
battery pack.
2. Charge the battery pack for at least
five hours before operating solely on
battery power.
Low Battery
Battery pack may be
worn out.
Battery life is approximately one to three
years depending on its use and care. Order a
replacement battery pack. Refer to page
1
for information on disposal of the battery
pack.
The ribbon has run out. Change the ribbon. Out of Ribbon
The ribbon is folded or
mangled due to improper
installation or label jam.
1. Remove the ribbon.
2. Manually advance the take-up spool
end towards you until the ribbon has a
smooth, flat surface.
3. Reinsert the ribbon in the printer.
There is a bad ribbon
sensor.
Contact BRADY’s Technical Support
Group.
TLS2200
™
Thermal Transfer Printer User Manual 65