User`s guide

Note: The battery pack is shipped in an uncharged condition. Charge the battery for a
minimum of five hours before operating the printer solely on battery power.
You can charge the battery pack while the battery power switch is turned on or off. The battery
pack charges as long as the charger is plugged in. BRADY recommends that once the battery
pack is fully charged, you should unplug the charger and operate the printer solely on battery
power. If the battery pack is completely discharged, connecting the charger does not provide
enough power to run the printer. Recharge the battery pack before continued use.
!
WARNING: Disposal of the Battery Pack
sidered The NiCad battery pack contains cadmium, a toxic element. The battery pack is con
hazardous toxic waste and must not be thrown away in the home or office garbage. Once the
useful life of the battery is ended (one to three years), contact your local authorities for
information regarding its proper disposal or recycling options.
Step 2. Install the Battery
1. Turn the battery power switch to the off
(O) position.
2. Slide the battery release lever to the
unlock position (slide to left).
3. Drop the battery in as shown and slide
forward.
4. Slide the battery release lever to the lock
position (slide to right).
Battery Power
Switch
(I)=On
(O)=Off
Battery
Battery
Release Lever
Step 3. Turn the Power On
Turn battery power switch to the on (I)
position.
TLS2200
™
Thermal Transfer Printer User Manual 5