User`s manual

TLS PC Link

Programmer’s Guide

Example 3 (0.24” continuous terminal block material, PTLTB-400-

240):

To print a terminal block label, it is necessary to set the label size and spacing. In

order to obtain this spacing, the printer must not be fed to the cut position

between terminal block positions on the label. The <STX>C command is used to

disable this function. This example is for a terminal block with a 0.5” pitch.

+5V +5V +5V GND GND GND GND GND GND +12V +12V +12V

<STX>n ;put printer in inches mode

<STX>P0050 ;set label length to 0.5”

<STX>S0000 ;set spacing to zero

<STX>C ;disable feed to cut after print

<STX>L ;enter label format mode

490000700450004+12V<CR> ;place +12V, rotated 270

degrees at

;location X=0.04”, Y=0.45”

X<CR> ;exit label format mode

<STX>E0003 ;set quantity to 3

<STX>G ;print 3 copies of this label

<STX>L ;enter label format mode

490000700400004GND<CR> ;place GND, rotated 270

degrees at

;location X=0.04”, Y=0.40”

X<CR> ;exit label format mode

<STX>E0006 ;set quantity to 6

<STX>G ;print 6 copies of this label

<STX>L ;enter label format mode

490000700400004+5V<CR> ;place +5V, rotated 270 degrees

;location X=0.4”, Y=0.40”

X<CR> ;exit label format mode

<STX>E0003 ;set quantity to 3