User`s manual

TLS PC Link

Programmer’s Guide

Set Column Offset Amount (C)

This command allows horizontal adjustment of the point where printing begins.

This is a left margin The ‘C’ command instructs the printer to print label formats

nnnn units to the right of the position that the format specifies.

Cnnnn

Where:

nnnn- is a four-digit number for the column offset, in/100 or mm/10—

the printer default is 0 for offset.

Sample:

<STX>L

C0050

190000901000100PCLINK<CR>

The above sample will shift all format data .5 inches to the right, unless the

printer is in metric mode, (see label-formatting command M).

Feedback possibilities: 0,1,2

Terminate Label Formatting Mode and Print Label (E)

When the printer is processing label-formatting commands and receives an ‘E’

command, it will immediately print a label based on the data it has received.

Even if no printable data has been received, the printer will generate and feed a

label, (other termination commands is ‘X’). Commands sent to the printer after a

terminate label command must be of either immediate or system.

E<CR>

Sample:

<STX>L

121100000000000Testing<CR>

E<CR>

The above label format will print a label.

Feedback possibilities: 1,2,6,7,8,A,B,C,D,E,F,G,H

Set Row Offset Amount (R)

This command allows vertical adjustment of the point where printing begins.

This is a top margin. The ‘R’ command instructs the printer to print label formats