User`s manual

TLS PC Link
TM
Programmer’s Guide
15
Form Feed (STX F)
This command feeds one label to the top of form.
Sample:
<STX>F
Feedback possibilities: 0,1,2,6,7,8,A,B,E,F
Set Form Stop Position (STX f)
This command is used to adjust the cutter stop position. When a label is printed,
the printer will feed the label to the cut position. This command adjusts the stop
position to allow for desired cutting alignment. When the next label format is
sent to the printer, it will automatically backfeed to the start-of-print position. If a
quantity of more than one label is to be printed (See Set Quantity for Stored
Label (STX E), the printer will operate without feeding to the cut position
between labels. It will feed to the cut position after the last label.
<STX>fsnn
Where:
s- sign of offset, ‘+’ or ‘-’
nn- two digit value of offset
The valid range is -08 to +08.
Sample:
<STX>f+08
The above sample adjusts the stop position 8 pixels from default. The ‘+’ means
that the paper will feed out 8 pixels further.
Feedback possibilities: 0,1,2,6,7,8,A,B,E,F